EGW HD Picatinny Rail Tikka T3X Tac A1 20 MOA

119.00

Machined From: Solid 7075 T6 Aircraft Grade Aluminum
Finish: Matte Black Only
Compatible with Picatinny or Weaver scope rings.
Mounting Hardware: (5) #6-48 X 1/4 Screws, (2) Recoil Pins, and T-10 Wrench Included
Torque Specs: 20 in/lbs

This mount is made specifically for the Tikka T3x Tac A1.

There is a screw in the front of the original mount that is located underneath the handguard. The handguard must be removed and then this screw must also be removed before the original mount can be removed.

Removing the original mount may be a difficult task. Please use caution when removing the original mount and when installing our mount. Please refer to our video above for mounting instructions. We always recommend having our products installed by a competent and qualified gunsmith.
Metric screws are only available with hex heads. Check out the Tikka FAQ page here for more info.

*The center spread is the distance between the two middle holes, center to center, on your receiver.

Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The cross slots are also machined the full width of the mount and gauged to MIL-STD 1913 specs maintaining tolerances of +/-.002″.

After machining; the mounts are tumbled and sand blasted. The aluminum mounts are Type III hard coat anodized for long lasting durability. The steel rails are Mil Spec parkerized for a durable rust resistant finish.

We recommend:
0 MOA – if shooting 0-500 yards
20 MOA – if shooting 500-1000 yards

Op voorraad